LEXMARK FORMS PRINTER 2390 PLUS DRIVER DETAILS:
|File Size:||3.0 MB|
|Supported systems:||Windows 10, Windows 8.1, Windows 8, Windows 7, Windows 2008, Windows Vista|
|Price:||Free* (*Free Registration Required)|
LEXMARK FORMS PRINTER 2390 PLUS DRIVER
Skip to main content. About this product.
Printing Output Type. Expansion Bays Type. Expansion Slots Form Factor. Free Qty.
System Requirements OS Required. Media Handling Media Path Type. Max Media Size Custom. Envelopes, labels, plain paper, continuous forms.
Make Your Selection
No ratings or reviews yet. Be the first to write a review. In order to use an Lexmark Optra T as a network printer, I have installed the driver from www. No redistribution.
Reconnect the connectors of all FRUs and printer interface cables. Check the continuity of the line cord. Electrical noise. Power supply ground. Machine frame ground. Printer interface cable is grounded or shielded.
Undefined data in customer applications. Check the baud rate at the controller. Check that the printer interface cable matches the printer. Perform the Trace Print hexadecimal printing by the following procedure and check the data streams. Turn the power off.
Turn the power on while pressing and holding Alt. Have the customer print the failing job. To stop printing, turn the power switch off. If the failure still occurs, replace the main logic board. Be sure to reset the bidirectional print adjustment, refer to lexmark forms printer 2390 plus "Bidirectional Print Adjustment" on page If the test is not successful replace the serial interface adapter. If no defect is found, the printer and serial interface adapter are working correctly. The problem may be with the interface cable, the computer, the printer driver, or the specific job lexmark forms printer 2390 plus sent. Model 2 and 3 printers have a "Lock" LED to indicate that the operator panel is locked. To unlock the operator panel, turn the printer off and then on while pressing Microt and Microi.
Replace the lexmark forms printer 2390 plus panel cable, the sub logic board, or the power cable as necessary. Check the continuity of the operator panel signal lines between the end of the short flexible cable and the operator panel connector on the sub logic board. If there is still a problem, replace the operator panel.
Forms Printers , , ,
If that does not fix the problem, re-install the old operator panel and lexmark forms printer 2390 plus the main logic board. If you replace the main logic board, reset the "Bidirectional Print Adjustment" on page Lexmark Forms Printer plus - printer - monochrome - dot-matrix overview and full product specs on CNET. : Lexmark Forms Printer plus - Printer - B/W - dot-matrix - A4 - dpi x dpi - 24 pin - up to char/sec - Parallel, Serial: Electronics.